Direct Ceiling Mounting with Painted Pucks

Before you start:

• Have your acoustical spec on hand for quick reference.

• Confirm that the pucks (A) are painted to match the panel color.

• Have appropriate mechanical fasteners (not provided by AcousticalFulFillment) to attach ceiling panels to the ceiling. Note: Puck opening is 3/16". Fasteners must be long enough to go through the puck and the panel and attach securely to the ceiling surface.

• Review all mounting instructions and drawings before panel installation. 

Mounting Instructions

1. According to your panel layout, mark each desired ceiling location.

2. Determine the location for Pucks on the first panel, per the location diagram for Puck mounting (C). Note: Make sure the puck is 6" in from the edge of the panel.

3. Cut a small “X” into the fabric to make inserting the puck's short stem into the panel easier. Gently peel the fabric back to expose the core. Repeat this process for each Puck location on the panel. Important: Do not cut “X” larger than the Puck’s diameter or peel fabric past the edge of the Puck.

4. Lift the panel, fabric facing down, into position against the ceiling. Note: Properly support the entire panel in this step!

5. Place the stem of the Puck (A, B) into position on the panel at each cut-out point and push into the fiberglass. TIP: Don’t pull on the fabric to ensure a seamless look once the puck is installed.

6. Insert mechanical fastener (not included) through the puck and panel, and secure into ceiling structure (B).

7. Tighten fastener until snug. TIP: To keep a smooth look on the panel face, do not over-tighten!

8. Repeat the process until all panels are securely installed.