Rotofast™ Snap-on Anchors

Rotofast™ Snap-on Anchors are a seamless and secure mounting method for installing acoustical panels on walls or ceilings. 

Rotofast™ Snap-on Anchor Components

Specifications

Stabilized polypropylene plastic. Non-reactive, will not chemically react with fiberglass binders.

Pull-out strength: 45lb in 6lb per cubic feet rigid fiberglass board

Mounting Instructions- for Wall or Ceiling

Before you start: 

1. Determine how many Snap-on Anchors are required for your panel size(s). 

2. Have the following tools and supplies available:

Rotofast™ Snap-on Anchor Components:

• Level 
• Tape measure
• Pencil for marking panel placement
• Power screwdriver or drill
• Hammer
• Stud finder or common nail
• #8 screws (not included unless you purchased our 30-Pack)
• Hollow wall (drywall) anchors (not provided unless you purchased our 30-Pack)

3. Have a layout plan handy so you’ll know exactly where to place the panels. 

Wall or Ceiling Mounting Instructions

	1. Pre-mark and measure panel placement on the walls and ceiling. Mark the panel's orientation on its back with a pencil.
	2. With the Installation Tool, screw the Snap-on Anchor into the back of the panel. Important: Place anchors 6"-8” from the panel edge. Do not overtighten anchors.
	3. Insert the reusable Snap-On Marking Plug into the center of each Snap-on Anchor.
	4. Line up the back of the panel with your markings on the wall for proper placement (check that panel orientation is correct) and press the Snap-on Marking Plugs against the wall to indicate ratchet locations.
	5. At the marked locations, screw the Snap-On Ratchet to the wall with a #8 screw and a hollow wall anchor where necessary. (Check each mark location for a stud with a stud finder. If none is available, use a common nail and hammer and tap the nail at the mark location to see if it hits a stud. If none is found, use a hollow wall anchor.) Note: The flat end of the Snap-On Ratchet goes against the wall, and the curved end faces out.
	6. Remove the Snap-On Marking Plug from the Snap-on Anchor.
	7. Line up the panel so that each Snap-On Ratchet engages with the center of each Snap-On Anchor. Firmly strike the panel onto the Snap-On Ratchets to complete the installation